Randome movement of rings

Daniel8769 · **Randome movement of rings -** 08-03-2017, 03:21 AM

On lab three I got the code out for the collision of the cone and ring with no problem. My issue was the up down movement and the random placement in the world. I had that ring shooting all over the place and any time it came down it found just one location to do so. A void moving the ring to the ground. It will always go to one section of the ground in the world. Best to just use Move Up and Move Down. I had issues with the ring staying off the view of the camera. I set up boundary limitations and had the right left movements reset its variable so that it would find its way back to the center of the world. If anyone is having a hard time with the scoring you should go back to your code for assignment 6 with the counting of bottles.

sptaylor17 · 08-03-2017, 09:52 AM

Did you use dummy rings to anchor the actual ring back to the starting position? Where did you find this collision code at in the book?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

	#1 (permalink)
Daniel8769 Junior Member Status: Offline Posts: 8 Join Date: Jul 2017 Location: Grand Prairie, Tx	Randome movement of rings - 08-03-2017, 03:21 AM On lab three I got the code out for the collision of the cone and ring with no problem. My issue was the up down movement and the random placement in the world. I had that ring shooting all over the place and any time it came down it found just one location to do so. A void moving the ring to the ground. It will always go to one section of the ground in the world. Best to just use Move Up and Move Down. I had issues with the ring staying off the view of the camera. I set up boundary limitations and had the right left movements reset its variable so that it would find its way back to the center of the world. If anyone is having a hard time with the scoring you should go back to your code for assignment 6 with the counting of bottles.

	#2 (permalink)
sptaylor17 Member Status: Offline Posts: 30 Join Date: Jul 2017	08-03-2017, 09:52 AM Did you use dummy rings to anchor the actual ring back to the starting position? Where did you find this collision code at in the book?