View Single Post
Old
DickBaldwin
Guest
 
Status:
Posts: n/a
Default 02-15-2008, 07:03 PM

Quote:
Originally Posted by DrJim View Post
For a line, you could try the cylinder from http://www.alice.org/community/showt...light=cylinder
(the cylinder in shapes is a bit short to work well) and then just orient, move and resize it in one direction as needed – quick example attached. An added move by half it’s length in one direction would be needed to make the “line” end on the “point” – and of course multiple line segments and points would be needed at the start.

A lot of work to get 3D - but it should be possible. You could also do curves much the same way with multiple torus segments.
Thanks DrJim,
That might do the trick.

Dick Baldwin
Free Alice tutorials: http://www.dickbaldwin.com/tocalice.htm
Free programming tutorials: http://www.dickbaldwin.com/toc.htm
   
Reply With Quote