View Single Post
Old
DrJim
Guest
 
Status:
Posts: n/a
Default 02-15-2008, 03:01 PM

For a line, you could try the cylinder from http://www.alice.org/community/showt...light=cylinder
(the cylinder in shapes is a bit short to work well) and then just orient, move and resize it in one direction as needed – quick example attached. An added move by half it’s length in one direction would be needed to make the “line” end on the “point” – and of course multiple line segments and points would be needed at the start.

A lot of work to get 3D - but it should be possible. You could also do curves much the same way with multiple torus segments.
Attached Files
File Type: a2w Point & Line.a2w (192.7 KB, 353 views)
   
Reply With Quote