07-15-2015, 04:11 PM
There is no "Tilt" command.
When you click on an object, you will see both the yellow bounding box, and
Also the colored lines that indicate up/down, left/right, and forward/backward. These lines converge at the center point of the objects design.
Just write a short piece of code that tests each of the turn and roll options that are available for the penguin, so you can watch what they do.
Also note that the results are based on the position of the center point, so some objects might not react the same way.
Last edited by MrMoke; 08-06-2015 at 07:59 AM.
|