Methods

Mauricio · **Methods -** 09-17-2016, 04:44 PM

The methods where not particular difficult, as mention before it just was a lot of trial and error. Probably the hardest part was setting the poses for the two characters, setting poses manually was cumbersome and not very efficient. The option of right clicking on the object and generating the poses took some getting used to, but with the use of the quad view, it made setting the character poses easier than doing it manually. However with this same option it was hard to manipulate the characters limbs and extremities back to its original position.
On a separate but related topic, I could not figure out how to write that statement for text assignment question EX 2.7. I am not looking for someone to give me the answer, but perhaps an overall direction on how to put the stamen together. I tried to use the variable count, an increment parameter, the + operator, and then 1 but I could not figure out if this is correct, and if it is, how to use it where it would actually count. If someone can provide any input I would greatly appreciated.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

	#1 (permalink)
Mauricio Member Status: Offline Posts: 14 Join Date: Aug 2016	Methods - 09-17-2016, 04:44 PM The methods where not particular difficult, as mention before it just was a lot of trial and error. Probably the hardest part was setting the poses for the two characters, setting poses manually was cumbersome and not very efficient. The option of right clicking on the object and generating the poses took some getting used to, but with the use of the quad view, it made setting the character poses easier than doing it manually. However with this same option it was hard to manipulate the characters limbs and extremities back to its original position. On a separate but related topic, I could not figure out how to write that statement for text assignment question EX 2.7. I am not looking for someone to give me the answer, but perhaps an overall direction on how to put the stamen together. I tried to use the variable count, an increment parameter, the + operator, and then 1 but I could not figure out if this is correct, and if it is, how to use it where it would actually count. If someone can provide any input I would greatly appreciated.